Zebra TC52x/TC52ax/TC57x Elec Trigger Assembly - TRG-TC5X-ELEC1-02

• Uses electrical trigger via contacts on back side of Zebra TC52x, Zebra TC57x and Zebra TC52ax non-Healthcare models.
• Use Trigger Handle with mechanical trigger operation for other Zebra TC5X models.
• Trigger Handle attaches to the mounts on the Rugged Boot (required). There are no mounting points on the terminal itself.
• Provides access to rear facing camera and flash allowing camera to be used while using the trigger handle.

Requires (Sold Separately):

• Rugged Boot/Exoskeleton without hand strap (SG-TC5X-EXONHS-01).

Rugged Boot/Exoskeleton with handstrap (SG-TC5X-EXO1-01) can also be used, but the hand strap will need to be removed before using with the trigger handle.

Important - Please Note!

For Zebra TC52ax units with SE55 Advanced Range Imager - These devices require instead:

• Rugged Boot/Exoskeleton with Handstrap (SG-TC52AX-EXOLOL-01). Hand strap will need to be removed.

Please Contact Us prior to purchase if your unclear as to your exact requirements.

The Zebra TC5X trigger handle accessory is considered a consumable item which may need to be replaced during the life of a Zebra TC5X device. Therefore, Zebra highly recommends the purchase of a Zebra OneCare trigger handle service plan.